| Problem |
Possible Correction |
1. Motor runs but does not pump water.
|
- Check for air trapped in pump housing - Check for broken impeller or bag insert not in
properly.
|
2. Filter powders continue to come through into the aquarium.
|
- Bag insert not properly in place - check filter bag for holes or open seams
|
3. Filter powder do not coat evenly and water flow is not good.
|
- Bag is plugged where powders do not coat - remove and clean or replace.
|
4. Intake hose collapses.
|
- Check for plugged or restricted slot in intake strainer.
|
5. Algae growing in filter jar and on bag.
|
- Place filter in dark area or cover with something to eliminate light
|
6. Motor noisy and air coming out exhaust hose - flow good.
|
- Check impeller for gravel or other cause.
- Check intake hose and fitting for air leaks.
|
7. Water leak at exhaust "U"-tube.
|
- Check hose clamps and "U"-tube for casting lines.
|
8. Water hazy or smoky - filter flow is good but aquarium will not clear.
|
- Probably a bacteria or amoeba form of life - usually after new water is put into the
aquarium - and is too small for the filter to take out. Condition will correct itself in a
few days.
|
9. Air collects in pump housing and breaks pump prime.
|
- Exhaust hose does not lead off in an upward angle to eliminate air from system - keep
intake downspout away from stones and bubblers
- Disconnect from power momentarily and allow the air to escape.
|
10. Water leaks from around jar top area.
|
- "O"-ring has filter powder or part of the filter bag under it - remove, clean
and lubricate with silicone grease or vasoline before reinstalling. Be sure filter bag
clears jar mouth and seal.
|
11. Water leaking between motor and main casting.
|
- P-16 seal worn ut or has been forced off center - replace or relocate. Lubricate with
P-31 grease before reassemlbing.
|