How to Charge Your Diatom Filter
Cut off the top of the Diatom Filter Powder charge and fill with water to the water line indicated on side of bag. Mix conents and pour into filter jar. Now, fill Diatom Filter jar half full of water. (Fig. 6-a, Fig. 6-b)
There are two different methods of charging the Diatom® Filter. Once a Diatom® Filter has been assembled the method desribed later in "Option #2 Alternate Method of Recharging" seems to be the most preferred by store owners and other who would rather backflush the unit clean.
Securing the casting assembly to the jar: be sure that none of the filter bag is caught between the rubber seal and the jar.
The Mode D-1 has a flat gasket seal. Align the pump assembly with the gasket on the jar lip and tightn the jar ring. (Fig. 7)
The Model XL has an "O"-ring seal. Push the casting completely down to where the thumbscrews go in at a point below the bottom ridge on the outside of the jar top. (Fig. 8-a, 8-b)
|How To Remove Hose Kinks|
© Copyright 2002 by Vortex Innerspace Products, Inc. All
All logos, graphics, marks and text are the sole property of Vortex Innerspace Products, Inc.